Fan; Figure 20. Fan Removal - Dell Latitude LS Service Manual

Fan

Figure 20. Fan Removal

1. Remove the keyboard bezel.
2. Remove the display assembly.
3. Remove the keyboard assembly.
4. Remove the palmrest assembly.
5. Carefully disconnect the fan wire connector from the system board
6. Remove the two M2 x 3.5-mm screws that secure the fan to the bottom
7 .
To replace the fan, perform the following steps:
1. Place the fan in the bottom case.
2. Reinstall the M2 x 3.5-mm screws to secure the fan the bottom assembly.
3. Reconnect the fan wire to the connector on the system board assembly.
support.dell.com
M2 x 3.5-mm screws (2)
(see Figure 20).
The male connector on the fan wire is keyed to fit into the female
connector one way only.
assembly (see Figure 20).
Remove the fan from the bottom assembly.
Make sure that the arrow that is stamped on top of the fan is pointing
towards the thermal cooling solution.
Dell Latitude LS Portable Computers Service Manual
fan
connector
27