Display Assembly Hinges - Dell Latitude LS Service Manual

16 Dell Latitude LS Portable Computers Service Manual
6. With bezel side of the inverter facing down, connect the two-wire
back-light plug to the connector on the right side of the inverter.
When the plug is all the way in the connector, the key slot in the center of
the plug should not be visible. If you can see the key slot, the plug is not in
the connector correctly. Pull the plug out, turn the plug over, and reinsert it
into the connector.
7 . Roll the inverter over (away from you), so the bezel side of the inverter is
up.
8. Place the inverter into the top cover, aligning the posts in the top cover
with the alignment holes in the inverter.
9. Holding the inverter in place, reinstall the M2 x 3.5-mm screw that secures
the inverter to the top cover.
10. Reinstall the four M2 x 3.5-mm screws, in the left and right ends of the top
cover, that secure the LCD panel to the top cover.
11. Reinstall the display assembly latch.
12. Reinstall the display assembly bezel.

Display Assembly Hinges

1. Remove the keyboard bezel.
2. Remove the display assembly.
3. Remove the display bezel.
4. Remove the two M2.6 x 4-mm screws that secure the left hinge to the top
cover (see Figure 9).
5. Remove the two M2.6 x 4-mm screws that secure the right hinge to the
top cover.
When replacing the left and right hinges, make sure they are installed
correctly. An L is stamped on the left hinge and an R is stamped on the right
hinge.