Steps
1. Connect the battery cable to the connector on the system board.
2. Place and snap the base cover into place on the palm-rest and keyboard assembly.
3. Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
4. Replace the six screws (M2x5) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Install the
SD
card.
2. Follow the procedure in
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
46
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.