Clarion DXZ776USB Owner's Manual page 14

Basic Operations
Adjusting Sound Mode
To change sound mode
1. Press the [ ] button and select the sound
mode to adjust.
2. Push the [SEEK PANEL] leftward or
rightward to select the "item
name".
When speaker system is "NORMAL":
"S-W VOLUME"
"BASS" "TREBLE"
"HPF" "S-W LPF"
"FADER"
When speaker system is "3WAY":
"S-W VOLUME"
"BASS" "TREBLE"
"BALANCE"
When speaker system is "2WAY":
"DZE" "P.EQ"
"S RESTORER"
"FADER"
3. Push the [P.CH] button upward or
downward to select the "desired setting
value".
In the case of item names appearing with
the "ENT" suffix after the item name, the
[ ] button must be pressed to display
the setting value.
"P.EQ" can be adjusted only when the
"P.EQ ON/OFF" is set to "ON" (page 19)
and "EQ SELECT" is set to "P.EQ" (page
19).
"BASS" and "TREBLE" can be adjusted
only when "DZE" is set to "DZE OFF" (page
12) and "EQ SELECT" is set to "B/T" (page
19).
After completing settings, press the
button to return to the previous mode.
Note:
• During sound adjustment mode, if no operation
is performed for more than 10 seconds, this
mode can be canceled and return to the
previous mode.
12
DXZ776USB
"DZE" "P.EQ"
"S RESTORER"
"BALANCE"
"DZE" "P.EQ"
"S RESTORER"
"BASS" "TREBLE"
"BALANCE"
[ ]
Adjusting the subwoofer output
volume
You can adjust the volume output from the unit's
subwoofer output terminal.
"S-W VOLUME" can be adjusted only when
"SUB WOOFER" is set to "ST" or "MONO"
(page 19).
2-1. Select the "S-W VOLUME".
3-1. Push the [P.CH] button upward or
downward to change the output volume.
The factory default setting is "0".
(Setting range: +6 to –6)
Setting the Digital Z-Enhancer
This unit are provided with 3 types of sound
tone effects stored in memory. Select the one
you prefer.
The factory default setting is "DZE OFF".
2-1. Select the "DZE".
3-1. Press the [
3-2. Push the [SEEK PANEL] leftward or
rightward to select the tone effect. Each
time you push the [SEEK PANEL], the tone
effect changes in the following order:
"DZE OFF" "DZE 1"
3"
DZE OFF : no sound effect
DZE 1 : Suitable for genuine speakers
DZE 2 : Suitable for separate
speakers
DZE 3 : Suitable for co-axial speakers
3-3. When the "DZE 1", "DZE 2" or "DZE 3" is
set, push the [P.CH] button upward or
downward to change the DZE level from +3
to –3
The factory default setting is "0".
] button.
"DZE 2" "DZE