Installing The Vga Card - Clevo D900C Service Manual

Disassembly

Installing the VGA Card

1. Prepare to fit the VGA card
2. The card needs to be fully into the slot, and the VGA card and socket have a guide-key and pin which align to allow
the card to fit securely.
3. Fit the connectors firmly into the socket, straight and evenly.
Figure 10
4. DO NOT attempt to push one end of the card in ahead of the other.
VGA Card
5. The card's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket
Installation
as it will go (none of the gold colored contact should be showing). DO NOT FORCE the card; it should fit without
much pressure.
a. Carefully Insert the VGA
6. Secure the card with screw
Card.
7. Place the heatsink
8. Attach the VGA card fan and secure with the screws as indicated in
9. Reinsert the component bay cover, and secure with the screws as indicated in
a.
25. VGA card
2 - 14 Removing the VGA Card
into the slot by holding it at about a 30° angle.
25
(Figure 9g on page 2 -
24
back on the card, and secure the screws in the order indicated in
23
25
13).
Figure 8 on page 2 -
Figure 8 on page 2 -
Figure 8 on page 2 - 12.
12.
12.