Clevo D900C Service Manual page 36

Disassembly
6. Gently pull the two release latches
Figure 6
arrows
RAM Module
7. The RAM module
Removal (cont'd.)
.
e. Pull the release
latch(es).
d. Remove the mod-
ule(s).
Contact Warning
Be careful not to touch
the metal pins on the
8. Pull the latches to release the second module if necessary.
module's connecting
edge. Even the cleanest
9. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
hands have oils which
10. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
can attract particles, and
as it will go. DO NOT FORCE IT; it should fit without much pressure.
degrade the module's
11. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
performance.
12. Replace the RAM fan, cover and screws.
13. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
18. RAM Module(s)
2 - 10 Removing the System Memory (RAM)
&
16
(Figure e).
will pop-up (Figure
18
e.
on the sides of the memory socket in the direction indicated by the
17
f), and you can then remove it.
f.
17
18
16