Adjustment / Settings - Canon MP830 - PIXMA Color Inkjet Service Manual

3-3. Adjustment / Settings

(1) Paper feed motor adjustment
Perform the following adjustments when the paper feed motor unit is replaced:
1) When attaching the motor, fasten the screws so that the belt is properly stretched (in the direction indicated by the blue arrow
in the figure below).
2) After replacement, be sure to perform the service test print, and confirm that no strange noise or faulty print operation (due to
dislocation of the belt or gear, or out-of-phase motor, etc.) occurs
Note: The red screws securing the paper feed motor may be loosened only at replacement of the paper
feed motor unit. DO NOT loosen them in other cases.
(2) Grease application
1) Machine unit
No Part name
Chassis ass'y
1
Chassis ass'y
2
Adjust plate L
3
Chassis ass'y
4
Chassis ass'y
5
Carriage shaft
6
Carriage shaft spring
7
L
Adjust plate R
8
Carriage shaft
9
Where to apply grease/ oil
Entire surface the carriage slider contacts
PR lift shaft cam contact portion (at 3
locations)
Carriage shaft cam L sliding portion
Carriage shaft sliding portion on the left side
of the chassis (at 2 locations)
Carriage shaft sliding portion on the right
side
of the chassis (at 2 locations)
Entire surface of the carriage shaft where
the carriage unit slides
Carriage shaft sliding portion
(to the end of spring)
Carriage shaft cam R sliding portion
Carriage shaft surface where the carriage
sliders
(and where machine-application of the grease
Grease/
oil name
KG107A
KG107A
KG107A
KG107A
KG107A
KG107A
KG107A
KG107A
KG107A
1-38
Grease/ Number
oil of
amount rops*
Floil 27 to 54
mg
Floil 9 to 18
mg
Floil 18to 36
mg
Floil 9 to 18
mg
Floil 9 to 18
mg
Floil 200 to
400 mg
Floil 9 to 18
mg
Floil 18 to 36
mg
Floil 9 to 18
mg
Number
of
locations
to apply
grease/
oil
3 1
1 3
2 1
1 2
1 2
1
1 1
2 1
1 1