Table of Contents
Advertisement
Parking Lights Flash Rate (Normal Operation)
Flashes
Doors locked, starter kill armed.
End of run time.
TRUNK
1
signal received by the module.
START
Cold weather mode cancelled.
Cannot start after maximum number of attempts is reached.
Run time cancelled.
Exiting remote valet mode
2
Remote start attempt cancelled by remote.
Exiting ignition valet mode
Doors unlocked, starter kill disarmed.
Entering cold weather mode
3
Entering remote valet
Entering ignition valet
+12 volts detected on the brake line; cranking cancelled
4
Entering tach programming
New Transmitter programmed
5
Tach programmed
Remote start attempt was made with a tach or a vacuum signal detected before
6
cranking
8
Unit reset: occurs when the unit is reset to factory defaults
10
The hood switch line went to ground during cranking or run time
1 – pause –
There was an attempt to start the vehicle while the module was in valet mode.
2
solid
Cold weather mode: the brake pedal is being held down
ON
The hood is up and the hood switch line went to ground. This is step one of the
2 sec.
ON
programming mode
First press of the
3 sec.
ON
Entering home valet mode
4 sec.
or
ON
LOCK
If the hood pin-switch has been pressed twice: the unit went into step 1 of the
programming cycle and no transmitter activity was detected for 20 seconds
25 sec.
ON
Or the unit went into step 1 of the transmitter code programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter code
programming procedure.
If the module gives irregular flashes (1 to 10 flashes followed by a pause, followed
Irregular
by more flashes), it is in playback mode. This occurs when the hood-switch line is
flashed 3 times.
Constant
Panic mode set off.
flashes
up to 30 sec.
User Guide
Description
button pressed
button under safe start.
START
pulse (if door pulse is configured to 4 sec.)
UNLOCK
P. 9
Advertisement
Table of Contents
