Table of Contents
Advertisement
Diagnostics – Parking Light Flash Table
Flashes
• Doors locked, starter kill armed.
• End of run time.
•
1
• Start signal received by the module.
• Cold weather mode cancelled.
• Doors unlocked, starter kill disarmed.
• Run time cancelled.
• Remote start attempt cancelled by remote.
2
• Exiting remote valet
• Exiting ignition valet
• Entering cold weather mode.
• Entering extended run time.
3
• Entering remote valet
• Entering ignition valet
• +12 V where detected on the brake line and cranking was cancelled.
4
• Entering tach-programming mode
• New transmitter programmed.
5
• Tach programmed.
• A remote start was attempted while a tach or a vacuum signal was detected
6
• Unit reset: occurs when the unit is reset to the factory defaults.
8
• The hood switch line went to ground during cranking or run time.
10
• There was an attempt to start the vehicle while the module was in valet
1 – pause – 2
• Cold weather mode: the brake pedal is being held down.
ON solid
• There was an attempt to start the vehicle while the module was in home valet
2 – pause – 2
• The hood is up and the hood switch line went to ground. This is step one of
ON 2 sec.
• First press of the
ON 3 sec.
• Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 4 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
ON 25 sec.
• Or the unit went into step 1 of the transmitter programming procedure and no
• If the unit gives irregular signals (1 to 10 flashes followed by a pause,
Irregular
Constant
• Panic mode is triggered.
flashes
up to 25 sec.
P. 16
button pressed
TRUNK
before cranking.
mode.
mode.
the programming centre procedure.
START
programming centre procedure, and no transmitter activity was detected for
20 seconds.
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.
followed by further flashes), the system is playing back start failure codes.
This occurs when the hood pin-switch is pressed three times
Description
button under safe start.
User Guide
Advertisement
Table of Contents
