Parking Lights Flash Rate (Normal Operation) - Autostart AS-6210 User Manual

Parking Lights Flash Rate (Normal Operation)

Flashes
1
2
3
4
5
6
8
10
1 – pause –
2
2 – pause –
2
ON solid
ON 2 sec.
ON 3 sec.
ON 4 sec.
ON 25 sec.
Irregular
Constant
flashes
up to 30 sec.
P. 11
• Doors locked, Starter Kill armed.
• End of Run Time.
•
button pressed
TRUNK
•
signal received by the Module.
START
• Cold Weather Mode cancelled.
• Cannot start after maximum number of attempts is reached.
• Run Time cancelled
• Remote start attempt cancelled by remote
Doors unlocked, Starter Kill disarmed
•
Exiting remote valet
•
Exiting Ignition Valet
•
• Entering Cold Weather Mode
• Entering remote valet
• Entering Ignition valet
• Extended runtime
• +12 volts detected on the Brake line; cranking cancelled
• Entering Tach Learning
• New Transmitter learnt
• Tach learnt
• Remote start attempt was made with a Tach or a vacuum signal detected
before cranking
• Unit reset: occurs when the unit is reset to factory defaults
• The Hood Switch line went to ground during cranking or run time
• There was an attempt to start the vehicle while the Module was in Valet
Mode.
• There was an attempt to start the vehicle while the Module was in Home
Valet Mode.
• Cold Weather Mode: the Brake Pedal is being held down
• The Hood is up and the Hood Switch line went to ground. This is step one
of the Programming Mode
• First press of the
• Entering Home Valet Mode
•
or pulse (if door pulse is configured to 4 sec.)
LOCK UNLOCK
• If the Hood Pin-switch has been pressed twice: the Unit went into step 1
of the Programming cycle and no Transmitter activity was detected for 20
seconds
• Or the Unit went into step 1 of the Transmitter Code Learning procedure
and no activity was detected for a few seconds. The Unit has exited the
Transmitter Code Learning procedure.
• If the Module gives irregular flashes (1 to 10 flashes followed by a pause,
followed by more flashes), it is in Playback Mode. This occurs when the
Hood-switch line is flashed 3 times.
• Panic Mode set off.
Description
button under Safe Start.
START
User Guide AS-6210