Cisco 6500-E Installation And Verification Manual page 16

Installing and Removing the Module
Figure 9
Press left
Press left
Exerting too much pressure on the ejector levers will bend and damage them.
Caution
While pressing on the ejector levers, simultaneously close them to fully seat the module in the
d.
backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate. (See
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
16
Clearing the EMI Gasket in a Vertical Slot Chassis
FAN
STATUS
o
o
INPUT
FAN OUTPUT
OK
OK FAIL
INPUT
FAN OUTPUT
OK
OK FAIL
Figure 10.)
Gap between the module
EMI gasket and the
module above it
1 mm