Cisco 6500-E Installation And Verification Manual page 14

Installing and Removing the Module
Figure 7
Note
Tighten the two captive installation screws on the module.
d.
Note
Vertical slots
a. Position the module in the slot. (See
carrier with the slot guides on the top and bottom of the slot.
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
14
Ejector Lever Closure in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
3
4
WS-C650 0-SFM
5
SWITCH FABRIC MDL
6
Failure to fully seat the module in the backplane connector can result in error messages.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
Switch Load
100%
PORT 1
PCMCIA
EJECT
1%
Ejector levers flush
with module faceplate
Figure 8.) Make sure that you align the sides of the module
PORT 2
PORT 2