Cisco 6500-E Installation And Verification Manual page 23

Using the screws or standoffs to seat the port adapter could warp the port adapter. Before you install and
Caution
tighten the securing screws, ensure that the port adapter is fully seated by visually verifying that the
bottom of the port adapter is in contact with the top of the mounting posts.
Install the two standoffs and two Phillips screws to secure the port adapter. (See
Step 8
Carefully turn the module component-side down, and place it on the antistatic mat or foam pad.
Step 9
Install the two remaining Phillips screws. (See
Step 10
Install the module into the Catalyst 6500 series switch or the Cisco 7600 series router; see the
Step 11
the Module" section on page
Installing and Removing an Ad-Hoc Conferencing and Transcoding Port
Adapter in Slot 4
Note The ad-hoc conferencing and transcoding port adapter is the only port adapter that can be installed in
slot 4. Slot 4 is located internally. (See
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034
Follow these procedures to remove and install an ad-hoc conferencing and transcoding port adapter in
slot 4:
•
•
Removing an Ad-Hoc Conferencing and Transcoding Port Adapter in Slot 4
To remove a port adapter in module slot 4, perform these steps:
Remove the module from the Catalyst 6500 series switch or Cisco 7600 series router; see the
Step 1
the Module" section on page
Carefully place the module, component side up, on an antistatic mat or foam pad with the front of the
Step 2
module facing toward you.
In Figure
Step 3
screws that secure the right-hand side of the port adapter.
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
10.
Removing an Ad-Hoc Conferencing and Transcoding Port Adapter in Slot 4, page 23
Installing an Ad-Hoc Conferencing and Transcoding Port Adapter in Slot 4, page 24
17.
13, note the location of the two slot 4 Phillips screw mounting posts. Remove the two Phillips
Figure 11.)
Figure 13.)
Removing and Replacing Port Adapters
Figure 12.)
"Installing
"Removing
23