Removing The Module - Cisco 6500-E Installation And Verification Manual

Figure 10
FAN
STATUS
e.
Note
This completes the module installation procedure.

Removing the Module

This section describes how to remove the module from a Catalyst 6500 series switch or the Cisco 7600
series router.
During this procedure, wear grounding wrist straps to avoid ESD damage to the module. Do not directly
Caution
touch the backplane with your hand or any metal tool, or you could shock yourself.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
Ejector Lever Closure in a Vertical Slot Chassis
All ejector levers flush
with module faceplate
Tighten the two captive installation screws on the module.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Installing and Removing the Module
17