TRENDnet TEW-714TRU User Manual page 16

TEW-714TRU User's Guide
Setup with WPS button: If you have the right to enable the WPS
4
pairing process on access point or router, you can copy the wireless
settings by pushing WPS buttons in this step. Otherwise, skip this
step and go to step 5 directly.
a) Push WPS button on the access point for 2 seconds.
b) Push WPS button on TEW-714TRU for 2 seconds.
c) The LED indicator will blink in green when proceed the pairing.
After pairing, if success, the TEW-714TRU will reboot. The LED
indicator will off for about a minute, then blink in amber, and
finally shows solid green. It means the repeater is setup properly.
© Copyright 2013 TRENDnet. All rights reserved.
5 Search for available wireless connections in your computer network
settings. The default SSID of TEW-714TRU is shown on the preset
label and the device label� This is the SSID that you will need to
connect to�
Preset label
on package
Enter wireless key manually� The default wireless key can be found
on the preset label on the package or on the device label on the
bottom of the TEW-714TRU.
Setup Wizards
Device label
with preset information
14