Sony PDWHR1 Installation Manual page 11

8. Turn the unit upside down, remove the six screws, and
then remove the bottom panel assembly.
n
After the bottom panel assembly is removed, be care-
ful not to damage the IC on the EM-8 board.
Bottom panel assembly
B3 x 6
EM-8 board
IC
9. When the TSI-60A board (PDBK-202) is mounted on
the VPR-15 board, remove the four screws and remove
the TSI-60A board.
CN100
CN400
VPR-15 board
PDBK-MK1
B3 x 6
B3 x 6
PSW2.6 x 6
TSI-60A board
10. Remove the nylon rivet from the VPR-15 board, and
install the supplied harness clamp instead.
11. Connect the supplied coaxial cable to the connectors
CN202, CN203, and CN204 on the VPR-15 board, and
then pass the coaxial cable through the harness clamp.
Coaxial cable
Harness
clamp
Nylon rivet
Connector
Support
Pass the coaxial cable between
the support and the connector.
12. Remove the nylon rivet from the NET-5 board, and
install the supplied harness clamp instead.
13. Connect the supplied harness (IF-DPR) to the connec-
tor CN2 on the IF-1101 board, and then pass the
harness through the harness clamp.
Harness (IF-DPR)
Harness
clamp
Nylon rivet
CN2 IF-1101 board
VPR-15 board
Red
Green
Blue
CN203
CN204
CN202
NET-5 board
1-3 (E)