Installing The Fujitsu Isis Scanner Driver - Fujitsu fi-4530C Getting Started

7. Documents are scanned, and the scanned
images are displayed on the [ScandAll 21] win-
dow.
If the scanning is completed without any troubles, the
installation was performed successfully.
For details on various types of scanning, refer to the
"fi-4530C Operator's Guide" on the Setup CD-ROM.
For FUJITSU ISIS Scanner Driver
■ Preparation
Confirm the following items before starting to install the
application. Prepare the Setup CD-ROM.
Confirm that the scanner is correctly connected to your
PC.
For details on how to connect the scanner,
refer to "2.2 Connecting the Scanner to
HINT
Your PC" on page 3.
■ Installing the FUJITSU ISIS Scan-
ner Driver
Windows XP screenshots are used in this
section. The windows and operations may
HINT
slightly vary depending on your OS.
1. Turn on the scanner.
2. Turn on your PC and log on to Windows.
.
ATTENTION
HINT
3. Insert the "Setup CD-ROM" into the CD drive.
⇒
ATTENTION
fi-4530C Image Scanner Getting Started
When using Windows NT 4.0, Windows
2000 or Windows XP, log on as a user
with "Administrator" privileges (privi-
leges of the administrator of your PC).
The scanner may be detected automati-
cally. If so, [Found New Hardware Wizard]
(or [Add/Remove Hardware Wizard]) will
appear. Click [Cancel] to close the Wizard
window. The window may slightly vary
depending on your OS.
The window below is a screenshot for Win-
dows XP.
<SETUP DISK START UP SCREEN> appears.
This screen may not appear when the
"Autoplay" setting of your PC is OFF. In
this case, run "Install.exe" in this CD-
ROM directly by the "Explorer" or "My
Computer".
9