Installation Tab; Preset Position - Sony Ipela SNC-RS86N User Manual

• Zoom: Configure the Zoom factor display setting.
• Codec: Configure the bit rate and frame rate display
settings. Displays the codec information for Image 1.
• Custom String: Set Custom String to display the
text of your choice.
Display format, including color, can be individually set
for each item.
Color: Select the font color of the superimposed text.
Blink: Select On to enable blinking for the
superimposed text. However, the blinking display is
not available for Date.
String Effect: Enable a string effect for displayed text.
Advanced: Click the Setting button in Date to
configure the format of date/time and the separator.
In Camera ID, you can configure the Camera ID
string setting and upload Superimpose Logo. Images
that can be used as a Logo must be in gif89a format
with an image size up to 320 × 60 (SNC-RS46N/P,
SNC-RS44N/P, SNC-RS86N/P, SNC-RS84N/P) or
640 × 120 (SNC-RH124, SNC-RH164). The number
of pixels horizontally is even numbered and the
maximum file size is approximately 50 KB. The
Camera ID string and Superimpose Logo can be used
exclusively.
Superimpose format
Click Edit to edit the content to superimpose over each
display position.
Only one Date and one Camera ID can be specified for
the Superimpose format.
You can set the content to superimpose in the bottom
left, bottom right, top left, top right, center, top middle,
and bottom middle parts, respectively. However, if you
specify the top middle, superimposed content will not
appear on the top left or top right. Similarly, if you
specify bottom middle, superimposed content will not
appear in the bottom left or bottom right.
If the Lower left/Lower right or Upper left/Upper
right are displayed at the same time, the maximum
image size that can be used for a logo is 624 × 120.
Click Date & Time, Camera ID, Codec, Zoom,
Camera Direction or Event to insert the corresponding
tag into the string.
Camera Direction
In the Superimpose format, select the content that will
be replaced by a <direction> tag inserted when the
Camera Direction is clicked. Select either of Azimuth
or Area title.

Preset position

Checking here will display the preset name when the
camera faces the direction registered as preset. This also
makes the preset name appear overriding the azimuth
and area title.
Azimuth
Displays the azimuth with the direction specified in
North as north.
Mode: Select between 4-azimuth or 8-azimuth displays.
Selecting Off will disable the displaying of the
azimuth.
North: Change the direction of the camera and click
Set. This will set that direction as north. Click Call
to change the direction of the camera to the direction
set as north.
Area title
Selecting an area title will display the registered string
according to the direction the camera is facing.
Here, set the display name for the area the camera is
facing. The maximum number of areas that you can
register is 64, from No.1 to No.64.
1
Enter the string to display.
2
Put a check in the checkbox.
3
Move the camera to the specified lower left area and
click Lower left.
4
Move the camera to the specified upper right area
and click Upper right.
5
Click Set.
OK/Cancel
See "Buttons common to every menu" on page 34.

Installation Tab

You can perform settings related to installation.
Display sample: SNC-RH124
Video output mode
Configure or confirm the signal output settings from the
analog image output terminal of the camera.
SNC-RH124, SNC-RH164
You can change the signal setting for NTSC or PAL.
Select either of NTSC + IP or PAL + IP. No analog
image outputs when IP only is selected.
Configuring the System — System Menu
39