Installation Tab - Sony SNC-EP520 User Manual

Installation Tab

You can perform settings related to installation.
Display sample: SNC-EP550/ER550
Camera operating mode (SNC-EP550/
EP580/ER550/ER580/ER585/ER585H/
ZP550/ZR550)
You can switch the operating modes of the camera.
Select either 25 fps or 30 fps.
The settings of the camera operating mode are related to
the frame rate selected in the Video code tab.
When the camera operating mode is switched, the
message "This System will be rebooted. Are you sure?"
appears.
Click OK to reboot the camera, and complete the
settings.
HPoE LLDP function
Based on 802.3at, select whether to use the power
adjustment function by LLDP (Link-Layer-Discovery-
Protocol).
Select ON in the case of IEEE802.3at compatible power
adjustment by PSE (Power Sourcing Equipment).
Notes
• Before setting, check the specifications, power level
and settings of the PSE you are going to connect.
• If the PSE with which you will use this unit cannot
supply sufficient power and you set the HPoE LLDP
function to Off, the unit may not operate correctly.
• The HPoE LLDP function may be slow to start if the
LLDP function is set to ON and PSE is not used for
some LLDP functions.
Eflip
You can display flip vertical images on the computer.
Select Off when you hang the camera from a ceiling.
Select On when you install the camera on a rack, etc.
Note
Panorama images, thumbnails set in the Preset Setting
menu, privacy mask positions and motion detection
areas, etc., will not be inverted, even if the On/Off
setting of the inverted image is switched. To invert the
image, make the setting again.
32
Configuring the System — System Menu
Video out (SNC-ZP550/ZR550)
Set the video output from the BNC cable connected to
the SLOC port. When outputting video images, select
On.
Notes
• The format for video output signals varies depending
on the Camera operating mode setting. In Camera
operating mode, 30 fps is for NTSC and 25 fps is for
PAL.
• When Video out is set to On, the motion detection
function and Image 2 of Video codec will not be
available.
Stabilizer (SNC-EP520/EP521/ER520/
ER521/ER585/ER585H)
Set Stabilizer. When you select On, the camera image
vibration will be reduced on the place where this unit is
installed with vibration.
Notes
• When Stabilizer is set to On, the shooting angle of
view will be narrowed by 20%.
Using preset or cropping functions (SNC-ER585/
ER585H) will also narrow the shooting angle of view.
• If Stabilizer is set to On, the compensation will not be
effective depending on vibration.
• It will take some time before the effect of the
compensation appears after operating the camera's
pan, tilt or zoom functions.
• Since the SNC-ER585/ER585H models integrate the
rolling shutter and CMOS sensor, focal-plane shutter
effects may occur when using the stabilizer function.
OK/Cancel
See "Buttons common to every menu" on page 26.