The Connection/Power Menu - Sony VPLFH31/B Operating Instructions Manual

The Connection/Power Menu

The Connection/Power menu is used for setting for the connections and power.
Setting items
Network Setting
IP Address Setup
IP Address/ Subnet
Mask/ Default
Gateway/Primary
DNS/Secondary
DNS
Input-A Signal Sel.
Color System
*2
Standby Mode
Power Saving Mode
Direct Power On
Notes
*1: The image may not be adjusted properly depending on the type of input signal. In such a case,
adjust it manually to suit to the connected equipment.
*2: When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
28
The Connection/Power Menu
Description
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
When "Manual" is selected for "IP Address Setup," select the item
with the B or b key and input the value with V or v key. When all
items are entered, select "Apply" then press the ENTER key. The
entered settings will be registered.
Auto/Computer/Video GBR/Component: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC /PAL/SECAM/NTSC
3.58
to "Auto," selects the color system automatically when "S Video" or
"Video" is selected with the INPUT key.
Standard/Low: When set to "Low," lowers power consumption in
Standby mode.
Lamp Cutoff: The lamp turns off automatically and power
consumption is reduced if no signal is input for 10 minutes. The lamp
lights again when a signal is input or any key is pressed. In Lamp
Cutoff, the ON/STANDBY indicator lights in orange (page 36).
Standby: The power will be turned off automatically and the projector
goes to Standby mode if no signal is input for 10 minutes.
Off: The Power Saving Mode is released.
On/Off: When set to "On," you can turn the power on without going
to Standby mode when the AC power cord is connected to a wall
outlet. You can also unplug the AC power cord without going to
Standby mode when you turn off the projector.
You may unplug the AC power cord without going to Standby mode.
*1
/PAL-M/PAL-N: When set
4.43
*1