Sony VPLFH31/B Operating Instructions Manual page 30

VPL-FH36/FH31
Setting items
Edge Blending
Blending
Range
Zone Black
Level Adj.
*2
Blend
Gamma
Reset
*3
Screen Fitting
*4 *5
V Keystone
*4 *5
H Keystone
*5
Warping
Image Flip
Installation Attitude Right Side Up/Upside Down: Change the cooling setting to suit to the
High Altitude
*6
Mode
Screen Aspect
30
The Installation Menu
Description
On/Off: When set to "On," the Edge Blending function is enabled. Set to
"Off" when you do not project using multiple projectors.
Sets the edge blending width.
After selecting the blending position, a marker will be displayed.
Top: Adjusts the top width of the screen.
Bottom: Adjusts the bottom width of the screen.
Left: Adjusts the left width of the screen.
Right: Adjusts the right width of the screen.
Adjust so that the overlapped part is not noticeably bright when a dark
*1
image is displayed.
Select the correction zone "Adjust Zone 1" through "Adjust Zone 9," and
set the adjustment values.
Sets the mode of the gamma curve of the overlapped area.
Mode 1: Provides a gentle gamma correction curve.
Mode 2:
Mode 3:
Mode 4:
Mode 5: Provides a sharp gamma correction curve.
Resets the adjusted values to their default values.
HV Keystone/Warping: You can choose the way to correct image twist.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
The higher the setting, the narrower the top of the projected image. The
lower the setting, the narrower the bottom of the projected image.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
The higher the setting, the narrower the right side of the projected image.
The lower the setting, the narrower the left side of the projected image.
This is displayed when "Warping" is selected in "Screen Fitting."
Adjust: Corrects image twist.
Reset: Resets the adjusted values to their default values.
HV/H/V/Off: Flips the projected image horizontally and/or vertically
according to the installation method.
installation attitude. Continuing to use the wrong setting may affect
component reliability.
On/Off: Set to "On" when using the projector at an altitude of 1,500 m or
higher. Continuing to use the wrong setting may affect component
reliability.
16:10/16:9/4:3: For switching the display area to suit to the screen.