Connecting With Component/Video Gbr Equipment; Connecting The Ac Power Cord - Sony SRX-T105 Installation Manual

Connecting with Component/Video
GBR Equipment
Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a DVD recorder/player or analog video equipment
equipped with the component output, or an high-definition
equipment equipped with a video GBR connector.
Left side
INTER LOCK ETHERNET RS232C
Betacam, DVD recorder/player, etc.
Note
When connecting to the output of HD component
equipment, set "Signal Mode" of "Input Source" in the
PICTURE CONTROL window to "YPbPr", and when
connecting to the output of HD video GBR equipment, set
to "RGB".
For details, see page 25.
18

Connecting the AC Power Cord

DVI-D AUX
R(P /C ) G(Y/Y) B(P /C ) HD VD
r r b b
IN OUT
IN OUT
R/P / G/Y / B/P
r b
connectors
Component cable, etc
(not supplied)
to component output/
video GBR
Connecting the AC Power
Cord
Use an AC power cord that supports 8AWG, 250 V, 40 A
or higher.
Follow the steps below to connect the three-wire power
cord to the AC IN terminal on the left side of the projector.
WARNING
• Connection of the main power and the electric wiring
work should be done by qualified electricians only.
• Do not plug the power cord into the power supply before
completing the following operations.
1
Remove the two screws on the terminal cover and
remove it.
2
Remove the two screws on the cable clamp and
remove it.
3
Pass the AC power cord through the hole beneath the
terminal, and tighten the screw for each wire as
illustrated.
Cable clamp