Sony SRX-T105 Installation Manual page 13

4
Connect the connectors for power focus and zoom on
the lens to those on the projector.
The "FOCUS" and "ZOOM" indications will be found
on the connectors of the lens and the projector. Be sure
to connect each of them correctly.
Connector on the lens
5
Replace the lens cover and tighten it with the four
screws. Be sure to put the connectors and their wires
completely into the projector cabinet before replacing
the lens cover.
Notes
• After replacing the lens with a new one, be sure to
readjust the zoom and focus settings stored in each
FUNCTION button. Otherwise, error message "DATA
LOAD FAILURE LENS POSITION SENSOR" may
appear.
• When removing the screws from the lens to remove the
lens from the projector, be sure to hold the lens with your
hands so that the lens does not drop.
• When attaching the lens, be careful not to tighten the lens
too firmly.
• The lens scratches easily, so when handling it, always
• Avoid touching the lens surface.
Connector on the
projector
place it gently on a stable and level surface in a
horizontal position.
13
Attaching the Lens