Connecting The Projector; Connecting A Computer Equipped With A Dvi-D Connector - Sony SRX-T105 Installation Manual

Connecting the Projector

When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may
increase noise and reduce performance of picture
signals. When pulling out a cable, be sure to pull it out
from the plug, not the cable itself.
• When installing the optional input board, consult your
Sony dealer.
Refer also to the instruction manuals of the equipment to
be connected.
Connecting a Computer Equipped
with a DVI-D Connector
Connect a computer to the DVI-D connector on the
optional LKRI-004 DVI interface board or LKRI-005
HDCP DVI board attached to the input board attachment
part. A progressive DVI signal can be input.
Setting the DIP switch
Set the following DIP switch(es) at the bottom of LKRI-
004 and LKRI-005 boards depending on the input signal
type of the connected computer.
• S101 on LKRI-004 board
• S101 and S102 on LKRI-005 board
For details on setting the DIP switches, refer to the
Operating Instructions of LKRI-004 (supplied with LKRI-
004) or the Operating Instructions of LKRI-005 (supplied
with this projector).
Connecting with a computer
The illustration below shows an example of connection
with INPUT A of the projector.
16
Connecting the Projector
Left side
INTER LOCK ETHERNET RS232C
DVI-D connector
DVI cable
(not supplied)
to DVI output
Computer
HDCP (High-bandwidth Digital Content Protection) DVI-
D signal can also be input when the input signal with
specified resolution is input from LKRI-005.
For details, refer to the Operating Instructions of LKRI-
005.
Notes
• According to the input signal type, set "Signal Mode" on
"Input Source" in the PICTURE CONTROL window of
the SRX Controller. (page 25)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
DVI-D AUX
AUX connector