Kyocera TASKalfa 3051ci User Manual page 42

Syntax in PRESCRIBE
If you are not confident with programming in PRESCRIBE, we recommend that you
read the "PRESCRIBE II ".
P M
E ROGRAMMING ANUAL
The BARC command is used. The syntax described in the PRESCRIBE manual for
the BARC command is valid for the one-dimensional barcodes supported. As you will
see below, the syntax for two-dimensional barcodes is slightly different.
The following parameters exist, all of which – except the "Barcode type" parameter –
are optional. If these are entered, they must be separated by commas.
Barcode type, identity number for Datamatrix
100
Module size
The unit of module size is preceded by the UNIT command. We recommend that you
use dots (pixels) => UNIT D;.
Lowest symbol number
Values from 1 to 30. To understand what this parameter means, compare the
explanations for the h parameter in the section entitled "Syntax in PCL".
Highest symbol number
Values from 1 to 30. To understand what this parameter means, compare the
explanations for the h parameter in the section entitled "Syntax in PCL".
Type of coding
0 must always be entered.
Error correction level
0 must always be entered.
Amount of base data in bytes
The base data can be passed in three different ways.
42