Installation And Commissioning; Hardware Installation - Kyocera TASKalfa 3051ci User Manual

2 Installation and commissioning

2.1 Hardware installation

The software is supplied on a Compact Flash/Secure Digital card ('CF/SD card'). To
use this card, it has to be kept permanently in the printer. All you have to do to install
the card is to insert it into the slot in the printer.
Note that, for technical reasons, starting with Version 3.00 the Barcode Flash solution
is available as Type A and Type B/C. Please see the compatibility list to find the right
version for your device.
Where differences exist between the installation of Type A and Type B/C, these are
described below. Please ensure that the proper installation is available on the
compact flash card. You can use the directory to determine whether this is the case
and reprogram the card if necessary. You can do so by copying the right file to the
printer. Please observe the instructions in this regard at the beginning of the update
file.
Please nothe that only the PCL Barcode Flash cards can be re-programmed by the
end user. The KYOmulticode card (PCL Barcode Flash with Unicode font extension
and additional fonts) has to be re-programmed by Kyocera customer service if a
change between Type A and B/C or vice versa is necessary.
Note
Please note carefully the general tips on working with CF/SD cards in your
printer manual. This manual will also contain a description of where the
CF/SD slot is on your particular device.
Data and programs for Kyocera printers always have to be present in a particular
form on Compact Flash cards. In the case of the barcode solution, these are a
number of what are known as 'partitions' in which additional fonts and macros for the
status page and function calls are stored for the user in addition to the software.
The following partitions are available once the CF/SD card has been inserted:
Type A:
Barcode Status
Barcode Init
Barcode Remove
KM BC 3.02.1
BSTP
STP1
STP2
KM_Logo
Linedraw
Code39_4
Code39_8
EAN_10mil
21