Removing The Hinge Covers; Replacing The Hinge Covers - Dell Precision M4400 Service Manual

Back to Contents Page
Hinge Covers
Dell Precision™ Service Manual
Removing the Hinge Covers
Replacing the Hinge Covers
Removing the Hinge Covers
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
The hinge covers are not interchangeable; the left one covers the multimode DisplayPort and the right one covers the RJ-45 network connector.
1. Follow the procedures in Before Working on Your
2. Close the display and turn the computer over.
3. Remove the bottom of the base assembly (see
4. Remove the two M2.5 x 5-mm screws from each hinge cover.
5. Slide each hinge cover off the computer and lift to remove it.
1 display port 2 M2.5 x 5-mm screw (4)
3 RJ-11 network connector 4 hinge cover (2)
Replacing the Hinge Covers
1. Slide the left hinge cover over the display port and slide the right hinge cover over the RJ-45 network connector.
2. Replace the M2.5x5-mm screws in each hinge cover.
3. Replace the bottom of the base assembly (see
4. Follow the procedure After Working on Your
Back to Contents Page
Computer.
Removing the Bottom of the Base
Replacing the Bottom of the Base
Computer.
Assembly).
Assembly).