Commands - Fujitsu 50FH5037E-02 Oem Manual

6.3 Command
Commands sent from the host machine to the scanner are as listed in Table 6.2.
Command name
CLEAR
CONTROL
IMAGE
CONTROL
SUB WINDOW
CONTROL
START
READ
SENSE
RETURN
SENSE
IMAGE MODE
SENSE
SEND DITHER
SEND DITHER2
6 $ 4
Table 6.2 Commands
Command
code
44 This command initializes the scanner.
This command can be issued at any time.
58 This command sets the operation mode of
the scanner and the operation mode in the
main window.
5A This command sets the image processing
mode of the scanner.
5C This command sets the subwindow
attribute of the scanner.
53 This command reports the size of a
document to be read.
54 This command starts reading. The
scanner starts reading according to the
operation mode set previously.
41 This command requests a scanner status
report.
42 This command requests a status report on
the return of the flatbed scan.
43 This command requests a status report of
the image processing mode of each main
window and the number of pixels (in units
of a byte) per line in the X>direction.
46 This command transfers the dither and
overlay patterns.
47 This command transfers the dither, d
curve, or overlay patterns.
50FH5037E>02
Details