Profiles > Mobility Switch > Ethernet Link - Dell PowerConnect W-Airwave Configuration Manual

Table 45
Field
Query-response-interval (1-25
sec)
Query-interval (1-18000 sec)
Startup-query-interval (1-18000
sec)
Enable Igmp Snooping
Robustness-variable (1-7)
3. Select Add or Save. The added or edited profile appears on the Mobility Switch page, and on the details page.
Profiles > Mobility Switch > Ethernet Link
Use the Ethernet Link profile to configure autonegotiation, duplex, speed, and flow control for the port. Creating
an Ethernet Link profile does not apply the configuration to any interface or interface group.
Perform these steps to configure a Mobility Switch > Ethernet Link profile:
1. Select Profiles > Mobility Switch > Ethernet Link in the Navigation pane. The details page summarizes the
current profiles of this type.
2. Select the Add button to create a new Ethernet Link profile, or select the pencil icon next to an existing
profile to edit. Complete the settings as described in
Table 46
Field
General Settings
Folder
Name
Other Settings
Autonegotiation
Duplex
Speed (Mbps)
Flow Control
Dell PowerConnect W-AirWave 7.5 | Configuration Guide
Profiles > Mobility Switch > IGMP Snooping Profile Settings (Continued)
Default
10
125
31
Yes
2
Profiles > Mobility Switch > Ethernet Link Profile Settings
Default Description
Top Set the folder with which the profile is associated. The drop-down menu displays all folders
available for association with the profile.
Blank Enter the name of the profile.
Disabled Enables auto-negotiation of port speed.
Auto Sets the duplex to one of the following parameters:



Auto Sets the speed to one of the following parameters:






off Sets the flowcontrol to one of the following parameters:




Description
Specify the maximum query response time.
Specify the periodic interval at which queries are sent.
Specify the interval at which startup queries should be sent.
Enable or disable IGMP snooping.
Specify the expected IGMP packet loss on a congested network.
Table
Auto—Configures auto mode.
full—Configures full duplex mode.
half—Configures half duplex mode.
Auto—Negotiates bandwidth dynamically between 10 and 1000/10000.
10—10 Mbps.
100—100 Mbps.
10m_100m—10 to 100 Mbps.
1000—1 Gbps.
10000—10 Gbps.
Auto—Configures auto mode.
lossless—configures lossless mode.
on—configures on mode.
off—configures off mode.
46:
Configuration Reference | 99