Dell PowerConnect W-Airwave Configuration Manual page 81

Table 30
Field
Double Encrypt
Native VLAN ID
(0-4094)
SAP MTU
Bootstrap Threshold (1-
65535)
Request Retry Interval
Maximum Request
Retries
Keepalive Interval (30-
65535)
Dump Server
Telnet
SNMP Sys-contact
RFprotect Server IP
RFprotect Backup
Server IP
Configure Aeroscout
RTLS Server
Configure RTLS Server
Remote-AP DHCP
Server VLAN
(1-4094)
Dell PowerConnect W-AirWave 7.5 | Configuration Guide
Profiles > AP > System Profile Settings (Continued)
Default
No
1
8
10
10
60
No
No
No
Description
The double encryption feature applies only for traffic to and from a wireless client
that is connected to a tunneled SSID. When this feature is enabled, all traffic
(which is already encrypted using Layer-2 encryption) is re-encrypted in the IPSec
tunnel. When this feature is disabled, the wireless frame is only encapsulated
inside the IPSec tunnel. All other types of data traffic between the controller and
the AP (wired traffic and traffic from a split-tunneled SSID) are always encrypted in
the IPSec tunnel.
Enter the ID of the native VLAN. The supported range is from 0 to 4094.
Specify the Service Access Point (SAP) maximum transmission unit (MTU) in bytes.
The range is 1024 to 1578 bytes.
Enter a threshold value from 0 to 65,535.
Adjust the bootstrap threshold to 30 if the network experiences packet loss. This
makes the AP recover more slowly in the event of a failure, but it will be more
tolerant to heartbeat packet loss.
The default maximum request retries and bootstrap threshold settings are
recommended for most mesh networks; however, if you must keep your mesh
network alive, you can modify the settings as described in this section. The
modified settings are not applicable if mesh portals are directly connected to the
controller.
Enter in seconds the amount of time for retries. The supported range is from 1 to
65,535 seconds.
Maximum number of times to retry AP-generated requests. The default is 10 times.
If you must modify this setting, best practices are to use a value a value of 10,000 or
lower. The range is from 1 to 65,535.
Define the keepalive interval in a range of 30 to 65,535 seconds.
Enter the IP address for the dump server.
Enables Telnet in this system profile.
Enter an IP address to the value for SNMP sys_ contact, the SNMP system Sys
location.
Enter the IP address of the RFprotect server.
Enter an IP address.
When a Dell PowerConnect W controller is present in anDell PowerConnect W
RFprotect system, an Dell PowerConnect W AP that is acting as an RFprotect
sensor can be configured and managed from the controller. As a Managed Sensor,
the Dell PowerConnect W AP is managed by the controller but sends collected
security data about the wireless environment to an RFprotect Server.
Enable this option if you wish to support an Aeroscout RTLS server.
Enable this setting for Real-time Locating Systems (RTLS) server values and the
number of consecutive missed heartbeats on a GRE tunnel before an AP reboots
traps.
Specify the VLAN to be associated with the remote-AP DHCP server. This field
requires a remote access points license, when used.
Configuration Reference | 75