Getting Started; Softune Workbench Development Introduction - Fujitsu MB91360 User Manual

Mb91360 series starterkit

Hide thumbs Also See for MB91360:

Table of Contents

STARTERKIT MB91360

Chapter 3 Getting Started

3 Getting Started

Make sure you have Softune Workbench for FR installed on your PC and the evaluation

board is ready to use. For details refer to the Hardware and Software Installation chapters.

This chapter uses the available examples to illustrate some features of Softune Workbench.

Start Softune Workbench. Select "File – Open Project" to load the first example

"LEDdemo1.Prj". In the project tree on the left side, you can open the "source"-folder which

contains the source-files registered to this project. A double-click on one of the files will

invoke the built-in editor, which supports syntax-highlighting, tags and various other

functions.

Figure 2: Softune Workbench Editor

You may customize the editor by a right-click on the editor window.

Whenever you make changes to your source-files, you have to re-compile and link the

related files to produce a valid loadmodule (ABS-file). This is done using the MAKE-function.

MAKE invokes the assembler, C-compiler and linker for FR whenever necessary (only the

changed files will be re-compiled).

If you wish to re-compile the entire project regardless of any changes, you can use the

BUILD-function. To check for syntax-errors on a specific source-file, use the

COMPILE/ASSEMBLE function.

- 11 -

UG-910006-13

Table of Contents