Printing Quality Problems - Dell 5330dn Workgroup Mono Laser Printer User Manual

Mono laser printer
Hide thumbs Also See for 5330dn Workgroup Mono Laser Printer:
Table of Contents

Advertisement

Check the printer for the following:
The connection cable between the
computer and the printer is not
connected properly.
The connection cable between the
computer and the printer is defective.
The printer may be configured
incorrectly.
The printer driver may be incorrectly
installed.
The printer is malfunctioning.
The printer selects
The paper source selection in the printer
print materials from
properties may be incorrect.
the wrong paper
source.
A print job is
The job may be very complex.
extremely slow.
Half the page is
The page orientation setting may be
blank.
incorrect.
The paper size and the paper size
settings do not match.
The printer prints,
The printer cable is loose or defective.
but the text is wrong,
garbled, or
incomplete.
The wrong printer driver was selected.
The software application is
malfunctioning.
The operating system is malfunctioning.
Pages print, but are
The toner cartridge is defective or out of
blank.
toner.
The file may have blank pages.
Some parts, such as the controller or
the board, may be defective.
The illustrations print
The setting in the software application
incorrectly in Adobe
is wrong.
Illustrator.

Printing Quality Problems

 
The inside of the printer may be dirty or improper paper loading may reduce the print quality. See the table below to clear the problem.
Condition
Suggested solutions
Light or faded print
If a vertical white streak or faded area appears on the page:
l
l
l
l
l
If a printer system error occurs, contact your
service representative.
Disconnect the printer cable and reconnect
it.
If possible, attach the cable to another
computer that is working properly and print
a job. You can also try using a different
printer cable.
Check the printer properties to ensure that
all of the print settings are correct.
Remove the printer driver and then reinstall
it. See
"Installing Software in Windows"
respectively.
Check the display message on the operator
panel to see if the printer is indicating a
system error.
For many software applications, the paper
source selection is found under the Paper
tab within the printer properties. Select the
correct paper source. See
Reduce the complexity of the page or try
adjusting the print quality settings.
The maximum print speed of your printer is
50 PPM for Letter-sized paper.
Change the page orientation in your
application. See
Ensure that the paper size in the printer
driver settings matches the paper in the
tray.
Disconnect the printer cable and reconnect.
Try a print job that you have already
printed successfully. If possible, attach the
cable and the printer to another computer
and try a print job that you know works.
Finally, try a new printer cable.
Check the application's printer selection
menu to ensure that your printer is
selected.
Try printing a job from another application.
Exit Windows and reboot the computer.
Power the printer off and then back on
again.
Thoroughly shake the toner. See
"Redistributing
If necessary, replace the toner cartridge.
Check the file to ensure that it does not
contain blank pages.
Contact a service representative.
Print the document by selecting Download
as Bit Image in the Advanced Options
window of the Graphic properties.
The toner supply is low. You may be able to temporarily extend the toner
cartridge life. See
"Redistributing
Toner". If this does not improve the print
quality, install a new toner cartridge.
The paper may not meet paper specifications; for example, the paper is too
moist or too rough. See
"Paper
Specifications".
If the entire page is light, the print resolution setting is too low or the toner
save mode is on. Adjust the print resolution and turn the toner save mode
off. See
"Graphic
Tab".
A combination of faded or smeared defects may indicate that the toner
cartridge needs cleaning. See
"Cleaning the
The surface of the LSU part inside the printer may be dirty. Clean the LSU
(see
"Cleaning the
Interior").
The front or rear door is not closed.
l
Paper is jammed.
l
No paper is loaded.
l
The toner cartridge is not installed.
l
"Uninstalling Software"
and
"Paper
Tab".
"Layout
Tab".
Toner".
Interior".

Advertisement

Table of Contents
loading

Table of Contents