Replacing The Camera - Dell Inspiron 1210 Service Manual

Back to Contents Page
Replacing the Camera
Dell™ Inspiron™ 1210 Service Manual
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Follow the instructions in Before You
2. Remove the display assembly. See Follow the instructions in "Before You Begin" on page 9..
3. Remove the display bezel. See
4. Remove the display panel. See
1 2-in1 camera and LVDS cable connector
5. Remove the camera board out of the protrusions that secure it firmly to the display frame.
6. Disconnect the 2-in-1 camera and LVDS cable from its connector on the display frame.
7. Remove the camera board.
8. To replace the camera, connect 2-in-1 camera and LVDS cable to its connector.
9. Align the camera board with the protrusions on the display frame.
10. Press the board gently until it sits firmly in the display frame.
11. Replace the display panel. See
12. Replace the display bezel. See
13. Replace the display assembly. See Follow the instructions in "Before You Begin" on page 9..
14. Slide the battery into the battery bay, until it clicks into place.
Back to Contents Page
Begin.
Replacing the Display Bezel.
Replacing the Display Panel.
2
Replacing the Display Panel.
Replacing the Display Bezel.
camera board