Replacing The Display Bezel - Dell Inspiron 1210 Service Manual

7. To replace the display assembly, route and connect the display cable to the connector on the system board.
8. Route and connect the 2-in-1 camera and LVDS cable to the connector on the system board.
9. Replace the four M2.5 x 3-mm screws on each side of the display assembly.
10. Replace the palm rest. See
11. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
Replacing the Display Bezel
NOTICE: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1. Remove the display assembly (see Follow the instructions in "Before You Begin" on page 9.).
1 M2.5 x 5-mm screws (2)
3 display bezel
2. Remove the two rubber bumpers at the bottom of the display bezel on either side.
3. Remove the two M2.5 x 5-mm screws at the bottom of the display bezel on either side.
4. Using your fingertips, carefully pry up the inside edge of the display bezel.
5. Remove the display bezel.
6. To replace the display bezel, align the display bezel over the display panel, and gently snap into place.
7. Replace the two M2.5 x 5-mm screws at the bottom of the display bezel on either side.
Replacing the Palm Rest.
2 rubber bumpers(2)