Replacing The Power-Button Board - Dell Inspiron 1210 Service Manual

Back to Contents Page
Replacing the Power Button Board
Dell™ Inspiron™ 1210 Service Manual
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Follow the instructions in Before You
2. Remove the palm rest. See
1 M2.5x3-mm screw
3 power button cable
3. Turn the palm rest over and remove the M2.5x3-mm screw that secures the power button board to the palm rest.
4. Lift the power button board off the palm rest.
5. To replace the Power Button Board, insert the power button board into the tabs and tighten the M2.5x3-mm screw.
6. Replace the palm rest. See
7. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
Back to Contents Page
Begin.
Replacing the Palm Rest.
2 power button board
Replacing the Palm Rest.