Power Distribution Pca - HP Model 748 - VME Workstation Handbook
Hp model 748 service handbook
Hide thumbs
Also See for Model 748 - VME Workstation:
- Owner's manual (152 pages) ,
- Manual (12 pages) ,
- Installation manual (8 pages)
Table of Contents
Advertisement
Power Distribution PCA
1
Remove the EISA and VME card cages following the procedures given in this chapter.
2
Remove both power supplies following the procedures given in this chapter.
3
As shown in Figure 5-21, loosen the thumb screw, then slide the power distribution
PCA connector (located on wall assembly) down to disconnect from wall.
Figure 5-21
Power Supply and Chassis Parts Replacement
Removing the Power Distribution PCA from the Wall
5-37
Advertisement
Table of Contents
Troubleshooting
