Recovery Flash Rom Data On Tig Board; Adjusting The Density - Oki C9500dxn Maintenance Manual

4.2.5

Recovery Flash ROM data on TIG board

A 4MB Flash ROM that enables a user to register an arbitrary file is installed on the TIG board.
Note:
When a TIG board has to be replaced, print a file list of the information menu and check
the registered files before replacing the board.
Re-register necessary files when the TIG board is replaced.
4.3

Adjusting the Density

The auto density adjust mode is set to [Auto] when the printer is delivered, however, problems may
occur upon using the printer if the mode is set to [Manual]. Perform the procedure when the density
is improper.
Note: Perform the task when the printer is not in operation. Do not perform during warm-up.
) ) ) ) )
(1) Press several times and display [Color Menu].
1 1 1 1 1
(2) Press or
3 3 3 3 3
(3) Press .
The auto density adjustment will begin.
41956001TH Rev.1
5 5 5 5 5
and display [Density Adjust/Start].
Oki Data CONFIDENTIAL
124 /