●
NET SWITCH
In this mode, the machine distinguishes between fax and voice calls. This mode is available for certain
countries only and requires subscription to a network switch service.
Telstra FaxStream™ Duet (Only for Australia)
In Australia, Telstra offers the FaxStream™ Duet capability. If you subscribe to this service, your line is assigned
two numbers: one for fax and one for telephone. When the fax number is called, the network sends a specific
ringing tone which your machine recognizes and automatically handles as a fax call. If the telephone number
is called, a different ringing tone is sent out from the network so that the call is handled as a voice call. This
means that there is no switching delay at the caller's end.
Contact Telstra for connection information.
–
Triple ring (short-short-short) for fax receiving.
Three short rings, at regular intervals.
–
Any ring except triple ring (depending on your switchboard) for telephone conversation.
Before using this mode
Make sure to do the following:
–
Subscribe to the FaxStream service.
Connect the optional handset or your external telephone to the machine. (See "Make Fax Settings, " in the
–
Starter Guide.)
–
Set the receive mode to <NET SWITCH>. (See "Selecting the Receive Mode , " on p. 5-10.)
Telecom FaxAbility (Only for New Zealand)
In New Zealand, Telecom N.Z. offers the FaxAbility capability. This service allows you to assign two numbers to
your line: one for fax and one for telephone. When the fax number is called, the network sends a specific ring
tone which your machine recognises and automatically handles as a fax call. If the telephone number is called,
a different ring tone is sent out from the network so that the call is handled as a voice call. This means that
there is no switching delay at the caller's end.
Contact Telecom for connection information.
Before using this mode
Make sure to do the following:
–
Subscribe to the FaxAbilty service.
Connect the optional handset or your external telephone to the machine. (See "Make Fax Settings, " in the
–
Starter Guide.)
–
Set the receive mode to <NET SWITCH>. (See "Selecting the Receive Mode , " on p. 5-10.)
Introduction to Using Fax Functions
5-9