11. Remove the three screws that secure the palm-rest assembly to the computer base.
1
screws (3)
2
12. Turn the computer over.
13. Remove the six screws that secure the palm-rest assembly to the computer base.
14. Turn the computer over.
15. Carefully pry out the palm-rest assembly from the two tabs along the rear edge of the computer, and then ease the palm-rest assembly from the
computer base.
CAUTION:
Carefully separate the palm-rest assembly from the computer base to avoid damage to the palm-rest assembly.
16. Lift the palm-rest assembly off the computer base.
17. Remove the power-button board (see
18. Remove the status-light board (see
Replacing the Palm Rest
1. Follow the instructions in
Before You
2. Replace the power-button board (see
3. Replace the status-light board (see
4. Align the palm-rest assembly on the computer base and gently snap the palm-rest assembly into place.
palm-rest assembly
Removing the Power-Button
Removing the Status-Light
Board).
Begin.
Replacing the Power-Button
Replacing the Status-Light
Board).
Board).
Board).