Wireless Mini-Card - Alienware M18x Service Manual

Back to Contents Page
Wireless Mini-Card
Alienware M18x Service Manual
Removing the Mini-Card
Replacing the Mini-Card
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
NOTE: Dell or Alienware does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell or Alienware.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one half-Mini Card slot for WLAN.
NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card
1. Follow the instructions in Before You
2. Remove the battery pack (see
3. Remove the base cover (see
4. Disconnect the antenna cables from the Mini-Card.
5. Remove the screw that secures the Mini-Card to the system board.
1 screw 2 antenna cables (2)
3 Mini-Card
6. Lift the Mini-Card out of the connector on the system board.
Begin.
Removing the Battery Pack).
Removing the Base Cover).
Removing the Battery Pack) before working inside the