Replacing The Display Assembly; Procedure; Postrequsites - Alienware M17x R4 Owner's Manual

34
WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.

Procedure

1 Place the display assembly in position and replace the screws that secure the display
assembly to the computer base.
2 Route the display cable, camera cable, infrared cable, wirelessHD card cable, and
Mini-Card antenna cables through the routing guides on the palm rest assembly.
3 Connect the display cable to the connector on the system board.
4 Tighten the captive screws that secure the display cable to the system board.
5 Connect the camera cable and infrared cable to the respective system board
connectors.

Postrequsites

1 Connect the wirelessHD card cable to the connector on the wirelessHD card. See
"Replacing the WirelessHD Card" on page 54.
2 Connect the Mini-Card antenna cables to the Mini-Card. See "Replacing the
Mini-Card" on page 51.
3 Replace the keyboard. See "Replacing the Keyboard" on page 48.
4 Replace the center control cover. See "Replacing the Center Control Cover" on
page 44.
5 Replace the compartment door. See "Replacing the Compartment Door" on page 15.
6 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
7 Follow the instructions in "After Working Inside Your Computer" on page 11.
60
|

Replacing the Display Assembly

Replacing the Display
Assembly
Before working inside your computer, read the safety