Step 3 - Configure Xirrus Array Web Logins Page - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Xirrus array integration guide

Hide thumbs Also See for PowerConnect W Clearpass 100 Software:

Table of Contents

Step 3 – Configure Xirrus Array Web Logins Page

By default the amigopod comes pre-configured with Web Login templates (RADIUS Services

Web Logins) for all the major wireless manufactures. The Xirrus template can be modified to

suit the local deployment by adding custom HTML code or defined a unique amigopod skin for

each captive portal page hosted by the amigopod installed; as shown below:

From the RADIUS Services  Web Logins page select the Xirrus Login entry and Click the Edit

button.

Please note the Xirrus Login template assumes the Virtual Interface address is the default

setting of 185.0.0.1.

The Virtual Interface IP address is used only in communications between the Array and wireless

clients. It never appears as the source or destination address of a packet that goes out a

distribution system port and onto the switched network. For the system to operate correctly, the

virtual interface IP address must be set (it cannot be 0.0.0.0), and no other device on the

network can have the same address as the virtual interface. Therefore, the virtual interface must

be configured with an unassigned and unused gateway IP address, such as 1.1.1.1. The virtual

interface IP address is not pingable and should not exist in any routing table in your network. In

addition, the virtual interface cannot be mapped to a backup port.

CONFIDENTIAL

Table of Contents

Need help?

Do you have a question about the PowerConnect W Clearpass 100 Software and is the answer not in the manual?

Amigopod