Step 2 - Confirm Dhcp Ip Address Received; Step 3 - Confirm Session Detected By Hp Procurve Controller - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Hp procurve msm integration guide

Hide thumbs Also See for PowerConnect W Clearpass 100 Software:

Table of Contents

Step 2 – Confirm DHCP IP Address received

Using the Windows Command Prompt or equivalent in the chosen operating system, confirm

that a valid IP Address has been received from the DHCP server configured on the HP

ProCurve Controller.

Issue the ipconfig command from the Windows Command Prompt to display the IP information

received from the DHCP process. By checking on the Wireless adaptor you should be able to

confirm an IP Address in the range of 192.168.1.x has been received.

Note: On Mac OS X and Linux operating system variants use a Terminal window and enter the

ifconfig command to display the same information.

Step 3 – Confirm session detected by HP ProCurve Controller

Once you have received an IP address, the HP ProCurve controller should have entry shown

under the Controlled APs section of the Management Tool as shown below:

CONFIDENTIAL

Table of Contents

Need help?

Do you have a question about the PowerConnect W Clearpass 100 Software and is the answer not in the manual?

Amigopod