Hp Procurve Msm Configuration - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

HP ProCurve MSM Configuration

The following configuration procedure assumes that the HP ProCurve MSM710 has been
powered up and a basic IP configuration has been applied through the steps detailed in the
Getting Started Chapter of the HP ProCurve Admin Guide. The following table again reviews the
IP Addressing used in the test environment but this would be replaced with the site specific
details of each customer deployment:
MSM710 IP Address
Internet Gateway Address
amigopod IP Address
amigopod RADIUS port
Depending on your network design the MSM710 may need to be configured to perform Network
Address Translation (NAT) on the Internet port. As can be seen from the previous Lab Topology
diagram, to simplify our lab routing environment NAT has been enabled.
If NAT is required in your network design, the MSM NAT settings can be found under Service
Controller  Network  Internet Port as shown below:
CONFIDENTIAL
10.0.20.25
10.0.20.1
10.0.20.60
Auth 1812 Acc 1813 (default settings)
12