Step 6 - Configure The Default Vsc - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Hp procurve msm integration guide

Hide thumbs Also See for PowerConnect W Clearpass 100 Software:

Table of Contents

Step 6 – Configure the Default VSC

A Virtual Service Community is defined by HP ProCurve as a collection of configuration settings

that define key operating characteristics of the service controller and controlled APs. In most

cases. A VSC is used to define the characteristics of a wireless network.

The VSC configuration can be accessed from the left hand pane of the Management Tool by

clicking on the + sign next to the Service Controller option. You will then be able to see the

default VSC available on the controller.

As you can see from the default settings shown below, both the VSC name and SSID for the

wireless is set to HP ProCurve. Obviously if the MSM is being used to control wired traffic only

access then the SSID is of little interest.

There are several other configuration settings within the VSC that are critical to the functioning

of this Guest access design. To make these changes enter into the default VSC configuration by

clicking on the HP ProCurve option below the VSC container.

CONFIDENTIAL

Table of Contents

Need help?

Do you have a question about the PowerConnect W Clearpass 100 Software and is the answer not in the manual?

Amigopod