Step 2 - Install Hp Procurve Multiservice Access Point (Optional) - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Step 2 – Install HP ProCurve MultiService Access Point (Optional)
Although the HP ProCurve MSM range of controllers are designed primarily for the centralized
control of HP ProCurve MulitService Access Points, the controller can be equally used for
providing Access Control in pure wired environments.
The many different methods of configuring the Controlled APs, AP Groups, Virtual Service
Community (VSC) is covered extensively in the HP ProCurve Admin Guide in Chapters 4 & 5
and is therefore considered outside of the scope of this Integration guide. Please refer to the HP
ProCurve Admin Guide for further information on these topics and the best method for
configuring your wireless environment.
For the lab environment used through the rest of this document, a single MSM320 will be used
and configured via the default AP Group and default VSC. As can be seen from the screenshot
below the MSM320 has been successfully detected, configured and synchronized with the
MSM710 and is available to start serving wireless clients.
16
CONFIDENTIAL