Modify Nas Id For Master Local Deployments - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

Arubaos integration guide
Hide thumbs Also See for PowerConnect W Clearpass 100 Software:
Table of Contents

Advertisement

Amigopod and ArubaOS Integration

Modify NAS ID for Master Local Deployments

In an Aruba master local deployment, you must modify the NAS ID of the local controllers to ensure
that the correct identifier is recorded in the RADIUS accounting traffic sourced from each local
controller that is responsible terminating the APs.
In the VRD campus topology, the local controllers are deployed on the 10.169.145.0/24 network
(VLAN 145). This network is used to send the RADIUS transactions toward the Amigopod deployed on
10.169.130.50.
Data center
AirWave
Internet
Local
mobility
controller
Based on the VLAN numbering in the VRD Local Controller deployment, the following modifications
are recommended:
Set the local controller NAS IP to the IP address on VLAN 145.
Define the source interface for RADIUS traffic to use VLAN 145 also.
These configuration changes must be performed on each local controller using the local interface of
the controller.
Aruba Networks, Inc.
Master
Amigopod
Master
active
standby
Air monitor
Application Note
File
POS
PBX
RADIUS
Local
mobility controller
ArubaOS Configuration
|
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Amigopodos 3.3

Table of Contents