Routing - D-Link DWR-512 User Manual

Section 3 - Configuration
The Routing page allows you to specify custom routes that determine how data is moved around your network. After modifying any
settings, click Save Settings to save your changes.
RIP:
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
D-Link DWR-512 User Manual
RIP SETTING
Select this box to enable routing, then
select which routing protocol to use:
• RIPv1: Protocol in which the IP address is
routed through the internet.
• RIPv2: Enhanced version of RIPv1 with added
features such as Authentication, Routing
Domain, Next Hop Forwarding, and Subnet-
mask Exchange.
ROUTING RULES
This identifies the rule.
Enter in the IP of the specified network that
you want to access using the static route.
Enter in the subnet mask to be used
for the specified network.
Enter in the gateway IP address for the specified network.
Enter in the amount of hops it will take
to reach the specified network.
Note: In a transmission path, each link is terminated at a
network device such as a router or gateway. The number
of hops equals the number of routers or gateways that
data must pass through before reaching the destination.
Select this box to enable the rule.

Routing

43