D-Link DWR-512 User Manual page 34

Section 3 - Configuration
WPS:
AP PIN (also known as
WPS PIN):
Config Mode:
Config Status:
Config Method:
WPS Status:
D-Link DWR-512 User Manual
Select whether you would like to enable
or disable WPS features.
If you use Windows 7's Connect to a network
wizard to do initial configuration of the router, you
will need to enter the WPS PIN/AP PIN into the
wizard when prompted. The factory default WPS PIN/
AP PIN is printed on a label located on the bottom
of the router. You can click the Generate New PIN
button to change it to a randomly generated PIN.
Select whether the WPS config mode should
be set to Registrar or Enrollee. In most cases,
this should be set to Registrar so that you can
use WPS to connect new wireless clients.
If this is set to CONFIGURED, the router will be marked
as "already configured" to computers that try to use
WPS configuration, such as Windows 7's Connect
to a network wizard. You can click the Release
button to change the status to UNCONFIGURED
to allow for WPS configuration of the router.
If this is set to UNCONFIGURED, you can click the
Set button to change the status to CONFIGURED
to block WPS configuration of the router.
This lets you choose whether to use the Push
Button connection method (PBC) or PIN method to
connect to a wireless client when the Trigger button
is clicked. If you choose the PIN method, you will
need to enter a 8-digit PIN number that the wireless
client need to use to connect to your router.
This will show the current WPS connection process status.
Click the Trigger button to initiate a WPS connection.
29