Chipset Configuration - Asus RS160-E4 PA4 User Manual

5.4.2 Chipset Configuration
This menu shows the chipset configuration settings. Select an item then press
<Enter> to display a pop-up menu with the configuration options.
Advanced
Chipset Configuration
Crystal Beach Configure Enable
SERR Signal Condition
Demand Scrub Enable
Patrol Scrub Enable
4GB PCI Hole Granularity
Memory Branch Mode
Branch 0 Rank Interleave
Branch 0 Rank Sparing
Branch 1 Rank Interleave
Branch 1 Rank Sparing
Enhanced x8 Detection
Force ITK Config Clocking
FBDIMM(s) Thermal Throttling
F1 Help Select Item
↑↓
ESC Exit Select Menu
→←
Scroll down to display the following item:
Open Loop Type
Environment Temperature
Temperature Rise
FBDIMM(s) Air Flow
F1 Help Select Item
↑↓
ESC Exit Select Menu
→←
Crystal Beach Configure Enable [Enabled]
Allows you to enable or disable the Configuration/Memory mapped accesses
to the Crystal Beach Configuration space located in Device 8, Fn 0, and Fn 1.
Configuration options: [Disabled] [Enabled]
SERR.Signal.Condition.[Single.Bit]
Allows you to select the ECC error that the SERR# asserts.
Configuration options: [None] [Single Bit] [Multiple Bit] [Both]
Demand.Scrub.Enable.[Enabled]
Enables or disables the Demand Scrubbing.
Configuration options: [Disabled] [Enabled]
Patrol.Scrub.Enable.[Enabled]
Enables or disables the Patrol Scrubbing.
Configuration options: [Disabled] [Enabled]
ASUS RS160-E4/PA4
PhoenixBIOS Setup Utility
[Enabled]
[None]
[Enabled]
[Enabled]
[256 MB]
[Interleave]
[4:1]
[Disabled]
[4:1]
[Disabled]
[Enabled]
[Disabled]
[Open Loop]
-/+ Change Values
Enter Select Sub-Menu
[Best Performan]
[025 ºC]
[025 ºC]
[2.0]
-/+ Change Values
Enter Select Sub-Menu
Item Specific Help
Enable Configuration/
Memory mapped accesses
to the Crystal Beach
Configuration space
located in
Device 8, Fn 0, and Fn 1.
F9 Setup Defaults
F10 Save and Exit
F9 Setup Defaults
F10 Save and Exit
5-23